simple   ramic
detailer

Simple Siramic - Detailer Instructions for use:

Simple Siramic - Detailer needs a clean surface for maximum effectiveness.  It can be applied to a cleaned surface before or after drying.

For wet application as a drying aid:

1. Wash vehicle well being sure to remove all bugs, tar and other persistent surface defects.  If certain areas have dried, apply more water to re-soak the surface. 

2.  While vehicle is still wet, spray directly onto wet surface one panel at a time.  Allow 15-30 seconds of dwell time, before beginning to rinse with low pressure water.  Do not allow product to dry completely without being rinsed.

3.  Being spraying from the lowest portion pushing the product and rinse water upward to ensure complete coverage of the area before the product is rinsed off.  Rinse well to ensure all of the product has been rinsed off before beginning next panel, to ensure any treated areas that may dry while treating remainder of vehicle.

4.  Once entire vehicle is treated, dry with a clean dry towel and admire your work and that brilliant shine!

Dry surface application:

1. Wash vehicle well being sure to remove all bugs, tar and other persistent surface defects.  Dry entire vehicle and if possible work with vehicle out of direct sunlight.

2. Simple Siramic - Detailer can be applied directly to the vehicle and then buffed out, or sprayed onto a clean, dry microfiber towel then applied and buffed to a brilliant shine.  Working in an area approximately 2 feet x 2 feet, is usually sufficient to allow the product to be easily buffed out to an even finish. If unable to work in the shade, keep the working space for application smaller to ensure best results.

3.  It is recommended when possible to keep vehicle from getting wet for 24 hours (from rain, sprinklers or anything else) to allow Simple Siramic - Detailer time to fully dry and cure.  If parking outside is required, it is best to apply in the morning or early afternoon, to allow for remainder of day for product to fully cure.

4. The size of your vehicle or boat will determine how many clean microfiber towels you will need to apply Simple Siramic - Deatiler to the entire vehicle.  Once your microfiber is saturated, grab a fresh one.

​

Things to remember and avoid:

- Simple Siramic - Detailer can be applied to a clean surface that hasn't been fully dried, then rinsed and towel dried.  This application method does allow​ for a thin layer of material to deposit on the surface.  However, more product runs off when you rinse and during the subsequent towel drying process, so expecting maximum durability and longevity if you take this application approach is unrealistic.  So if this is your "preferred" method, no problem.  Just know going in durability and longevity will suffer, and you will to a certain extent be wasting product.  We're happy to sell you more!